Henan Dorit Biotechnology Co., Ltd.
DORIT--do right
Add to Cart
DORIT Best Dental High Speed Handpiece 1: 5 Increasing Contra Angle Dentist Red Ring Stainless Steel NSK E Type
Increasing contra angle handpiece technical data
| Product Name | Increasing contra angle handpiece |
| Water Spray | 4 water spray |
| Spray | inner water spray |
| Bearing | Cramic;Janpan bearing |
| Connector | Electric motor |
| Speed | 200,000Rpm |
| Water Pressure | 0.08 - 0.20MPa (0.8 - 2.0kgf/cm 2 ) |
| Noise | 60-65dB |
| Gear Ratio | 1:5 Increasing |
| Disinfection | autoclavoble to 135 ℃ |
Fiber optic handpiece Description
Forever evolving, their dominating productivity and remarkable durability make them the most popular models in the lineup. 200,000 rpm speed range lets you complete the most intricate restorative work with incredible accuracy – and on your own terms.
1. Cartridge compatible with NSK Ti-max X95L
2. International E-type connector, High brightnessfiber optic light
3. Integrate sterilization make it clean simple and convenient.
4. Fiber optic LED light source, water/air channel isolation. keep perfect performance in instable air pressure and water pressure situation.
5. Made from copper (imported from Japan),durable and dirt free
6. Perfect atomization, cooling uniformity, no droplet out from mouth in use. clean hygiene.
7. Easy operation, good control, will not make the patient feel pain.
8. Autoclavable at up to 135°(275°F), avoiding cross-infection
Our services:
1. 100% pre-tested before delivery.
2. 1:1 replacement for any defective caused by our factory.
3. Specialized in exporting dental equipment with professional sales team.
After each patient use , maintenance should be done as follows:
1. First remove the diamond burs , and clean up all the teeth on dental handpieces precipitate
2. Use a metal needle to clean the spray holes and fumaroles
Note: The spray holes and diamond burs into 40 -degree angle , fumaroles and diamond burs to a 30 degree angle
3. Place the clean lubricating oil is sprayed into the axial hole 1-2 seconds ( diamond burs is plugged holes )
4. In the bottom of the handpiece were ( with / without quick connector ) two kinds of styling , make the right amount of lubricant is injected into the bottom
5. The handpiece with quick connector combination ( first determine the water switch is turned off )
6. Replace the diamond burs , surrounded by white silk cloth handpiece head ( make sure the needle does not touch the diamond burs and white gauze , so as not to tie )
7. pedal depressed for about 20 seconds , look at whether there is in white gauze on any stain. If there are stains on the white gauze , again, add oil , starting from item 4 continued routine maintenance , know that white gauze until no stain
8. Finally, no more than 135 degrees Celsius temperature and high pressure sterilization