Henan Dorit Biotechnology Co., Ltd.
DORIT--do right
Add to Cart
High Quality Low Noise Tripel Water Spraying LED High Speed Hand Pieces
DR-161 Dental LED High speed hand pieces
standard head / 2 hole/4 hole
LED Airotor HandpieceTech data:
| Name | Dental E-generator handpiece |
| Water Spray | 3 Water Spray |
| Drive air pressure | 0.25-0.3Mpa |
| Water pressure | 0.2Mpa |
| Water pressure | 198Kpa(2kg) |
| Handpiece Hole | 4Holes/2Holes |
| Light brightness | 25500lux |
| Power | 22W |
| Illuminate | LED Light (white light) |
| Rotation speed | 300,000~350,000rpm |
| Head height | 13.0mm |
| Head diameter | Φ12.7mm |
| Chuck type | Push button |
| Clamping force | 22N~34N |
| Torque force | ≥0.1N·cm |
| Bur Applicable | Φ1.59mm-Φ1.60mm*21mm-23mm(diameter*length) |
| Noise | ≤60DB |
LED Airotor Handpiece details:
|
dynamice balancing correction led lamp imported from Japan Triple water sparying |
|
newly designed package |
|
application: teeth grinding, cutting ,etc |
|
we are moving in updation the right photo is old type
|
After each patient use , maintenance should be done as follows:
1. First remove the diamond burs , and clean up all the teeth on dental handpieces precipitate
2. Use a metal needle to clean the spray holes and fumaroles
Note: The spray holes and diamond burs into 40 -degree angle , fumaroles and diamond burs to a 30 degree angle
3. Place the clean lubricating oil is sprayed into the axial hole 1-2 seconds ( diamond burs is plugged holes )
4. In the bottom of the handpiece were ( with / without quick connector ) two kinds of styling , make the right amount of lubricant is injected into the bottom
5. The handpiece with quick connector combination ( first determine the water switch is turned off )
6. Replace the diamond burs , surrounded by white silk cloth handpiece head ( make sure the needle does not touch the diamond burs and white gauze , so as not to tie )
7. pedal depressed for about 20 seconds , look at whether there is in white gauze on any stain. If there are stains on the white gauze , again, add oil , starting from item 4 continued routine maintenance , know that white gauze until no stain
8. Finally, no more than 135 degrees Celsius temperature and high pressure sterilization
