Henan Dorit Biotechnology Co., Ltd.
DORIT--do right
Add to Cart
High Quality Dental Fast Speed E Generator Fiber Optic LED Handpiece Standard Torque Push Button Quattro Spray
Fiber Optic Handpieces Features:
1. Quattrao spray fiber optic handpiece, Separted water and air outlets;
2. Push button chuck system, high working efficiency;
3. Water non-return valve prevent contaminated water from entering the fiber optic handpiece;
4. Selected Chrome-plated copper body, withstand high temperature and high pressure sterilization;
5. Fiber optic light, natural light, more brightness;
6. Kavo type coupling, led light, 2 hole, 4 hole, 6 hole for choice;
Fiber Optic Handpieces Tech data:
| Product name | Fiber optic dental handpiece |
| Drive air pressure | 0.25-0.3Mpa |
| Water pressure | 0.2Mpa |
| Light brightness | 25500lux |
| Power | 22W(standard head); 25W(torque head) |
| Rotation speed | 300,000~350,000rpm(Torque); 350,000~420,000rpm(Standard) |
| Head diameter | Φ12.5mm(torque)/ Φ11.2mm(standard) |
| Chuck type | Push button |
| Clamping force | 22N~34N |
| Torque force | 0.09-0.11N·cm(standard head); ≥0.13-0.14N·cm(torque head) |
| Bur Applicable | Φ1.59mm-Φ1.60mm*21mm-23mm(diameter*length) |
| Noise | ≤60DB |
Fiber optic handpieces detailed photos:
Product details:
Quattro water spraying
Quattro air spraying
Fiber optic light source, more stable
Push button to take turs,
Sandblasted and non-slip surface
Newly designed package
With insturments in, for opening caps, for lubrication etc
After each patient use , maintenance should be done as follows:
1. First remove the diamond burs , and clean up all the teeth on dental handpieces precipitate
2. Use a metal needle to clean the spray holes and fumaroles
Note: The spray holes and diamond burs into 40 -degree angle , fumaroles and diamond burs to a 30 degree angle
3. Place the clean lubricating oil is sprayed into the axial hole 1-2 seconds ( diamond burs is plugged holes )
4. In the bottom of the handpiece were ( with / without quick connector ) two kinds of styling , make the right amount of lubricant is injected into the bottom
5. The handpiece with quick connector combination ( first determine the water switch is turned off )
6. Replace the diamond burs , surrounded by white silk cloth handpiece head ( make sure the needle does not touch the diamond burs and white gauze , so as not to tie )
7. pedal depressed for about 20 seconds , look at whether there is in white gauze on any stain. If there are stains on the white gauze , again, add oil , starting from item 4 continued routine maintenance , know that white gauze until no stain
8. Finally, no more than 135 degrees Celsius temperature and high pressure sterilization
Contact us
Tell us your requirements, tell us product information,
we will haveckaging solution!